System Requirements; Printer Type; Preparation For Peripheral Devices - Novexx Solutions 64 Series User Manual

01/13 Rev. 5.05-01

System requirements

•
•
•
•
•
Peripheral test
•

•

Printer Peripherals preparatioPrinter Peripherals preparation
USER MANUAL
Rewinder 2000

Printer type

The rewinder can be operated with the following printer types:
TTX 350
TTK
64-xx
AP 5.4
AP 7.t

Preparation for peripheral devices

For using the printers with a rewinder, they must be especially equipped
(see Tab. 1). This so called peripherals preparation consists mainly of an
additional output stage board for the motor of the peripheral device and of
someadditional connection cables.
Printer Peripherals Preparation
64-xx Optional
TTX 350 Optional
TTK Standard
AP 5.4 Standard with printer version „Peripheral"
AP 7.t Standard
Tab. 1 Only the TTK is always equipped with the peripheral preparation. For the other
printer types this is an option.
Do the following, if you are not sure, wether the printer is equipped with
peripheral preparation:
TTK / TTX 350:
Set parameter SYSP > PEPH
If the printer displays the status message ST68 after the ENTER key is
pressed, the peripheral board is not installed. If ST68 does not appear or if
a different status message is displayed, then the printer has been set up for
peripheral devices.
64-xx / AP 5.4 / AP 7.t:
Make a service status printout: Call parameter
64-xx and AP 5.4 printers are equipped with peripheral preparation if the
topic "Peripheraldriver" can be found below the header "Peripheraldriver"
on the printout.
to KNIF.
PRINT INFO > Service
3
Attachment, Setup
Status.