Inserting Material - Novexx Solutions 64 Series User Manual

01/13 Rev. 5.05-01

Inserting material

Direction of rotation The material – depending on the set direction of rotation – is wound around
Proceed as follows:
1. Remove the guide disk (1). To do so,
open the clamping lever (2). Remove
the clamping bar (3).
2. Feed the end of the material web around
dancer arm and winding core and fix it
with the clamping bar. To do so, push
the clamping bar over the material (4).

If a cardboard core is used: Push the
clamping bar underneath the cardboard
core.
 Continued overleaf.
USER MANUAL
Rewinder 2000
the core in a clockwise or anti-clockwise direction (see Fig. 5).
1
Fig. 5 Left side: direction of rotation = left (labels outside); right side: direction of rotation =
right (labels inside)
1
4
Attachment, Setup
2
3
15