(Ap 5.4) Run-In Roller For Narrow Labels - Novexx Solutions 64 Series User Manual

01/13 Rev. 5.05-01
(AP 5.4) Run-in roller for
narrow labels
To improve the guiding accuracy of AP 5.4
printers processing very narrow label material,
it is recommended to install an additional run-
in roller (1) (article number A100422).
At older rewinders, an additional hole
according to fig. (2) must be drilled before
installing the run-in roller.
Tools:
2/2.5 mm allen keys
Assembling:
Screw the axle of the run-in roller to the

hole as illustrated (1).
Adjusting:
1. Measure the centre of the label material
and mark it (3).
2. Loosen the set screw (4).
3. Shift the roller on the axle until the
centre groove on the roller (5) is in front
of the mark (3) on the material.
4. Re-tighten the set screw (4).
Material path:

Insert the material so that it runs over
the roller (6).
USER MANUAL
Rewinder 2000
2
Countersunk 90°
6
1
23.50
Attachment, Setup
3
4
5
19