Starting; Starting Ttx 350 / Ttk; Starting 64-Xx / Ap 5.4 / Ap 7.T - Novexx Solutions 64 Series User Manual

01/13 Rev. 5.05-01

Starting

1. Press the CUT button.
2. Switch the printer on-line.
Cut button

Material end

1. Press the Cut button

2. Switch the printer on-line.
Cut button

Material end

USER MANUAL
Rewinder 2000
After securing the material end, proceed as follows to start printer and
rewinder:
The printer is set to off-line mode.

Starting TTX 350 / TTK

The rewinder starts rewinding, until the bouncer arm reaches the final
position. At that point, the rewinder stops.
If a printjob has already been loaded, both printing and rewinding start
nearly simultaneously.
Start or stop the rewinder by pressing the CUT button. This works in on-line
mode as well as in off-line mode.
With no material to rewind, the rewinder stops after approx. 4 s and shows
the status report:
ST13
Press the ON/OFF button to acknowledge the status report.

Starting 64-xx / AP 5.4 / AP 7.t

The rewinder starts rewinding, until the bouncer arm reaches the final
position. At that point, the rewinder stops.
It is essential to let the bouncer arm initially reach its final position after
starting. Only then, the bouncer arm takes control over the rotation speed
(explanation below).
If a printjob has already been loaded, both printing and rewinding start
nearly simultaneously.
Start or stop the rewinder by pressing the Cut button. This works in on-line
mode as well as in off-line mode.
With no material to rewind, the rewinder stops after approx. 6 s and shows
the status report:
Status 5004
Rewinder mat. tear
Press the Online button to acknowledge the status report.
17
Attachment, Setup
