Attaching The Rewinder - Novexx Solutions 64 Series User Manual

01/13 Rev. 5.05-01

Attaching the rewinder


Before beginning service work, switch
off the printer and pull out the mains
power supply plug!

Under no circumstances should you use
the dancer arm as a carrying handle! A
bent dancer arm will cause the device to
malfunction!
The rewinder (1) is attached to the front of the
printer (2) with two screws. The support leg (3)
absorbs some of the strain exerted by the
material roll.

Other options which may be installed or
the cover must be removed before
assembling the rewinder.
Tool
– Allan key 3mm
Assembly / Disassembling
1. Place the printer on a level surface.
Ensure that there is enough room in
front of the printer for the support leg (3)
of the rewinder.
2. Attach the rewinder housing (4) to the
printer recess (5) using the two screws
supplied.
3. Loosen the supporting leg fastening
screw (6). Push down the support leg
until it stands on the surface. Push up
the rewinder a little and at the same time
tighten the fastening screw.

The weight of the material roll should
rest on the support leg.
4. Plug in the connector plug (7).

Under no circumstances should the plug
be attached or removed
when the device is switched
on, as otherwise the device
electronics could be damaged.
USER MANUAL
Rewinder 2000
1
6
Attachment, Setup
2
4
3
7
4
5