Adjusting The Sensor - Novexx Solutions 64 Series User Manual

01/13 Rev. 5.05-01
3. Set the rewinder pot.
4. Move the bouncer arm to the
*) The value with the bouncer arm in its final position must be at least 80 higher than the value
1. Select parameter
2. Press the Online button
3. Move the bouncer arm appr.
USER MANUAL
Rewinder 2000
(Fig. 1) so that a value
between 20 and 30 is
displayed.
final position (towards the
support leg). Check the
displayed value*.
in zero position, which was set in step 3. Most important ist the difference between the two
values in the two end positions: the difference must equal/be higher than 80, ideally 100.
Repeat step 3 and set a higher value in the zero position, if the difference is too little.

Adjusting the sensor

The bouncer arm controls the winding speed of the rewinder by means of a
sensor. Bevor applying the rewinder for the first time, the bouncer arm has
to be brought in both end positions to adjust the sensor.
Fig. 4 Left side: bouncer arm in zero position; right side: bouncer arm in final position.
Action
SERVICE
FUNCTION > rewinder adjust
5 mm out of its resting (zero)
position. Press the Cut
button.
Sensor test
Sens: 4.01 27
Sensor test
Sens: 4.01 130
Display
rewinder adjust
rewinder adjust
Resting pos. xx
rewinder adjust
End pos. xx
13
Attachment, Setup
Bouncer arm in zero
position (Fig. 2); 27 =
set value.
130 = set value
(example) in the final
position; Value
difference = 103
(o.k.)
Note
If 0 jobs are stored in
memory.
xx = actual value
supplied by the
sensor; moving the
bouncer arm alters
the value
Mind the notes
following this table!