Configure Upnp Setup By Cpe Mode; Configure Snmp Setup - Cerio OW-215N2-X User Manual

6.3 Configure UPnP Setup by CPE mode

Universal Plug and Play(UPnP) is an architecture to enable pervasive peer-to-peer network
connectivity between PCs, intelligent devices and appliances when UPnP is supported. UPnP
works on TCP/IP network to enable UPnP devices to connect and access to each other, very well
adopted in home networking environment.
Please click System -> UPnP and follow the below settings
UPnP : By default, it's "Disable". Select "Disable" or "Enable" of UPnP Service.

For UPnP to work in Windows XP, the "OW-215N2-X" must be available in "My Network Places",
as shown here: (your specific model may vary)
If these devices are not available, you should verify that the correct components and services are
loaded in Windows XP. Please refer to Appendix D. Using UPnP on Windows XP
Click Save button to save changes and click Reboot button to activate changes

6.4 Configure SNMP Setup

SNMP is an application-layer protocol that provides a message format for communication between
SNMP managers and agents. By enabling SNMP function, the administrator can obtain the system
information remotely.
Please click on System -> SNMP and follow the below setting.
CERIO software core : cen_v3.0