Ap Mode Configuration; Choose Your Operating Mode ( Ap Mode ); External Network Connection; Configure Ow-215N2-X Lan Ip Address - Cerio OW-215N2-X User Manual

2. AP Mode Configuration

When AP mode is chosen, the system can be configured as an Access Point. This section provides
detailed explanation for users to configure in the AP mode with help of illustrations. In the AP mode,
functions listed in the table below are also available from the Web-based GUI interface.

2.1 Choose Your Operating Mode ( AP Mode )

OW-215N2-X Operating mode support four operational modes, AP mode, the WDS mode, the
CPE mode and the Client Bridge + Repeater AP mode, respectively with built-in remote
management features.
The system administrator can set the desired mode via this page, and then configure the system
according to their deployment needs, Please click on System -> Operating Mode and follow the
below setting.

2.2 External Network Connection

Network Requirement

Normally, OW-215N2-X connects to a wired LAN and provides a wireless connection point to
associate with wireless client. Then, Wireless clients could access to LAN or Internet by
associating themselves with OW-215N2-X set in AP mode.

2.3 Configure OW-215N2-X LAN IP Address

Here are the instructions to setup the local IP Address and Netmask
Please click on System -> LAN and follow the below setting.
CERIO software core : cen_v3.0