Features - Cerio OW-215N2-X User Manual

In the CPE mode, OW-215N2-X is a gateway enabled with NAT and DHCP Server functions.

The wired clients connected to OW-215N2-X are in different subnet from those connected to
Main Base Station, and, in CPE mode, it does not accept wireless association from wireless
clients.

1.4 Features

Operation Modes : AP Mode, WDS Mode, Client Bridge + Repeater AP Mode and WISP

Repeater + AP Mode
500mW at 5Ghz Output High Power

IEEE 802.11a/n 2Tx / 2Rx Design, Bandwidth of up to 300Mbps(Tx), 300Mbps(Rx) link rate

Maxmum Security with 802.1X, WAP, and WPA2

Support Over load current protection for the board design . and 3 LEDs Wireless Signal

Strength
Weater-Proof RJ45 Connector, Integragted Power over Ethernet (PoE)

Support PoE Bridge by LAN Port function.

Build in lightning arrester (15kV ESD)

Support 8 Multiple-BSSID. And Support IEEE802.11f IAPP

Support Static Routing and RIP and OSPF Dynamic Routing by CPE mode.

Support Layer-7 Protocol Filter and Content Filter by CPE mode.

QoS(Quality of Service) for bandwidth management and traffic prioritization

Support IEEE802.1d Spanning Tree

Integragted IGMP v1/v2/v3 snooping functions and Support Web management and SNMP

MIB-II
Built-in software interface allows for communicating with CERIO AM-Series AP Management

WLAN Switch or Access Controller of network management servers.

Networking by CPE mode.
Support Static IP, Dynamic IP(DHCP Client) and PPPoE on WiFi WAN Connection

Support VPN Pass Throughput ( PPTP , IPSec , L2TP ) and MAC Cloning

Proxy DNS ,Dynamic DNS ,NTP Client

Virtual DMZ, Virtual Server (IP / Port Forwarding) and

Support IP / MAC Filter and Support Bandwidth trafic Shaping

Wireless Feature
Transmission power control : Layer 1~9

Channel selection : Manual or Auto

No of associated clients per AP : 32

Setting for max no associated clients : Yes

Support 8 virtual BSSID and associated clients per AP to 32 and the Pure WDS Max. 8

CERIO software core : cen_v3.0