Cerio OW-215N2-X User Manual page 113

RIP Service : By default, it's Disable. To Enable to activated RIP routing service.

Side : Specify desired interface WAN, LAN for sending and receiving of RIP packets.

Distribute OSPF over RIP : Allow OSPF routes redistributed into RIP.

Change these settings as described here and click Save button to save your changes. Click
Reboot button to activate your changes
Static Routing Setup :
Service :
Click Enable to activated static routing.

Destination Net/Mask : Specify desired destination IP network address with format of A.B.C.D/M

Via : Select a next hop of Gateway or Interface to the destination IP network.

Gateway : Enter gateway IP address

Interface : Choose the interface via LAN or WAN

Protocol : Set static routing rule to RIP or OSPF network. Select RIP to associate specific

network on RIP routing process. Select OSPF to associate specific network with the specified
area on OSPF routing process
Click "Save" button to add Routing rule to List. There are maximum 20 rules allowed in this List. All
rules can be edited or removed on the List. Click Reboot button to activate your changes.
CERIO software core : cen_v3.0