Table of Contents
Advertisement
Description : Description of WDS link.
The WDS link needs to be set at same Channel and with same Security Type.
Click Save button to save your changes. Click Reboot button to activate your changes.
3.7 WDS Status
The Peers MAC Address, antenna 0/1 received signal strength, phy mode and channel bandwidth
for each WDS are available.
MAC Address : Display MAC address of WDS peer.
RSSI : Indicate the RSSI of the respective WDS's link.
TX/RX Rate : Indicate the TX/RX Rate of the respective WDS's link
TX/RX SEQ : Indicate the TX/RX sequence of the respective WDS's link
4.
Client Bridge + Repeater AP Mode Configuration
When Client Bridge + Repeater AP Mode is chosen, the system can be configured as an Client Bridge
+ Repeater AP Model. This section provides detailed explanation for users to configure in the Client
Bridge + Repeater AP Mode with help of illustrations. In the Client Bridge + Repeater AP Mode,
functions listed in the table below are also available from the Web-based GUI interface.
4.1
Chose Your Operating Mode(Client Bridge + Repeater AP)
The system administrator can set the desired mode via this page, and then configure the system
according to their deployment needs, Please click on System -> Operating Mode and follow the
below setting.
CERIO software core : cen_v3.0
Advertisement
Table of Contents
