Mac Filter By Cpe Mode - Cerio OW-215N2-X User Manual

7.3 MAC Filter by CPE mode

Allows to create MAC filter rules to allow or deny unicast or multicast packets from limited number
of MAC addresses. Important and must note. That MAC filter rules have precedence over IP Filter
rules.
Please click on Advance -> MAC Filter Setup and follow the below setting.
Click Save button to save your change. Two ways to set the MAC Filter List
MAC Filter Rule : By default, it's "Disable". Options are Disabled, Only Deny List MAC or Only
Allow List MAC.
Action :

 Only Allow List MAC:
The wireless clients in the MAC Filter List will be allowed to access to Access Point; All
others will be denied.
 Only Deny List MAC
The wireless clients in the MAC Filter List will be denied to access to Access Point; All
others will be allowed.
MAC Address :

Enter MAC address (e.g. aa:bb:cc:00:00:0a) and click "Add" button, then the MAC address
should display in the MAC Filter List.
There are a maximum of 20 clients allowed in this MAC Filter List. The MAC addresses of the
wireless clients can be added and removed to the list using the Add and Delete buttons.
Schedule : Can choose to use rule by "Time Policy"

Click Reboot button to activate your changes
CERIO software core : cen_v3.0