ZyXEL Communications XS1930-12HP User Manual page 33

You can change transceivers or DAC cables while the Switch is operating. You can use different
transceivers to connect to Ethernet switches with different types of fiber-optic connectors.
• Type: SFP or SFP+ connection interface
• Connection speed: 1 or 10 Gigabit per second (Gbps)
To avoid possible eye injury, do not look into an operating fiber-optic
module's connectors.
3.1.3.1 Transceiver Installation
Use the following steps to install an SFP/SFP+ transceiver.
Locate the transmit (Tx) and the receive (Rx) markings on the SFP+ module to identify the top.
1
Insert the transceiver into the slot.
2
Press the transceiver firmly until it clicks into place.
3
The Switch automatically detects the installed transceiver. Check the LEDs to verify that it is functioning
4
properly.
Close the transceiver's latch (latch styles vary).
5
Connect the fiber optic cables to the transceiver.
6
Figure 12 Transceiver Installation Example
Figure 13 Connecting the Fiber Optic Cables
3.1.3.2 Transceiver Removal
Use the following steps to remove an SFP/SFP+ transceiver.
Remove the fiber optic cables from the transceiver.
1
Open the transceiver's latch (latch styles vary).
2
Pull the transceiver out of the slot.
3
Chapter 3 Hardware Panels
XS1930 Series User's Guide
33