ZyXEL Communications XS1930-12HP User Manual page 60

Table 19 Navigation Panel Links (continued)
LINK DESCRIPTION
VLAN This link takes you to screens where you can configure port-based or 802.1Q VLAN (depending
on what you configured in the Switch Setup menu). You can also configure a protocol based
VLAN or a subnet based VLAN in these screens.
Static MAC This link takes you to a screen where you can configure static MAC addresses for a port. These
Forwarding static MAC addresses do not age out.
Static Multicast This link takes you to a screen where you can configure static multicast MAC addresses for
Forwarding port(s). These static multicast MAC addresses do not age out.
Filtering This link takes you to a screen to set up filtering rules.
Spanning Tree This link takes you to screens where you can configure the RSTP/MRSTP/MSTP to prevent
Protocol network loops.
Bandwidth This link takes you to a screen where you can configure bandwidth limits on the Switch.
Control
Broadcast Storm This link takes you to a screen to set up broadcast filters.
Control
Mirroring This link takes you to screens where you can copy traffic from one port or ports to another port
in order that you can examine the traffic from the first port without interference.
Link Aggregation This link takes you to screens where you can logically aggregate physical links to form one
logical, higher-bandwidth link.
Port This link takes you to a screen where you can configure IEEE 802.1x port authentication for
Authentication clients communicating via the Switch.
Port Security This link takes you to screens where you can activate MAC address learning and set the
maximum number of MAC addresses to learn on a port.
Time Range This link takes you to a screen where you can define different schedules.
Classifier This link takes you to screens where you can configure the Switch to group packets based on
the specified criteria.
Policy Rule This link takes you to a screen where you can configure the Switch to perform special treatment
on the grouped packets.
Queuing Method This link takes you to a screen where you can configure queuing with associated queue
weights for each port.
Multicast This link takes you to screens where you can configure various multicast features, IGMP
snooping, MLD snooping-proxy and create multicast VLANs.
AAA This link takes you to a screen where you can configure authentication, authorization and
accounting services via external servers. The external servers can be either RADIUS (Remote
Authentication Dial-In User Service).
Loop Guard This link takes you to a screen where you can configure protection against network loops that
occur on the edge of your network.
Layer 2 Protocol This link takes you to a screen where you can configure L2PT (Layer 2 Protocol Tunneling)
Tunneling settings on the Switch.
PPPoE This link takes you to screens where you can configure intermediate agent settings in port,
VLAN, and PPPoE.
Errdisable This link takes you to screens where you can view errdisable status and configure errdisable
settings in CPU protection, errdisable detect, and errdisable recovery.
Green Ethernet This link takes you to a screen where you can configure green Ethernet settings in EEE, auto
power down, and short reach for each port.
LLDP This link takes you to screens where you can configure LLDP settings.
IP Application
Static Routing This link takes you to a screen where you can configure IPv4 static routes. A static route defines
how the Switch should forward traffic by configuring the TCP/IP parameters manually.
DHCP This link takes you to screens where you can configure the DHCP settings.
Chapter 4 The Web Configurator
XS1930 Series User's Guide
60