Steps To Run Mail In Differential Weighing Modes - quadient IS-6000 User Manual

Steps to Run Mail in Differential Weighing Modes

In Differential Weighing Mode (
From the home screen:
1. Select the weighing mode, place the stack of mail (or container) on the Weighing
3
Platform, then follow the instructions on the screen or the steps below.
2. Remove the first piece of mail from the top of the stack. The Mailing System displays
the weight and postage, then automatically starts the Feeder and machine motors.
3. To print directly on the envelope, place the envelope on the hooper. Mail should be
placed against the rear wall and covering the optical (clear) sensor.
4. If the mail piece is too thick or too large to process through the machine, press [lable
Printing] to print a label. See
5. Repeat the previous steps for each piece of mail.
To quit at any time, press Back.
In Differential Weighing Auto-Tape Mode (
You may change the label dispenser (if you have the option remote label dispenser
installed) from the Differential weighing auto-tape screen. Then:
1. Select the weighing mode, place the stack of mail (or container) on the Weighing
Platform, then follow the instructions on the screen or the steps below.
2. Remove the first piece of mail from the top of the stack. The Mailing System displays
the weight and postage then prints the label automatically.
3. Repeat previous step for each piece of mail.
To quit at any time, press Back.
66
)
Mail Specifications
If you inadvertently remove more than one item from the WP,
replace removed items before the weight stabilizes in order to
avoid printing the label (about 1.5 seconds).
on page 363
)