Maintenance; Disassembling The Reel - Toro 04479 Operator's Manual

Maintenance

Note:
Determine the left and right sides of the
machine from the normal operating position.

Disassembling the Reel

Disassemble the reel whenever you need to change a
blade or replace the reel bearings.
Important:
Ensure that the 2 shaft retainers and
spacer are in place before installing the bearing
on the reel (Figure 10). Torque the insert nuts to
136 N∙m (100 ft-lb).
Figure 10
1. Left-hand threaded insert
nut
2. Bearing
3. Seal
If you install the optional spring steel dethatcher
blades (Part Number 121-6675), replace the end hex
spacer (Part Number 120-3232—shown in
with a main spacer (Part Number 120-3167).
Contact your authorized Toro distributor for parts
information.
Note:
The end hex spacer is located between a pair
of hex spacers and a hex nut as shown in
g016597
4. Spacer
5. Slot in shaft
6. Shaft retainer (install these
first)
Figure 11)
Figure 11.
1. End hex spacer
2. Hex spacers
9
Figure 11
3. Hex nut
g346400