Controls System Maintenance; Adjusting The Motion-Control Levers - Toro MB TX 2500S Operator's Manual

Figure 44
1. Bolt (2)
2. Pump mount
8. Remove the drive belt from the engine pulley
and 2 transmission pulleys.
Figure 45
1. Engine pulley
2. Idler pulley
9. Route the new belt around the engine pulley and
2 transmission pulleys
10. Install the gear pump
11. Install the extension spring
12. Install the fuel tank; refer to
Tank (page 27).
13. Raise the cushion.
g189559
3. Gear pump
4. Nut (2)
g189571
3. Transmission pulley (2)
4. Belt
(Figure 45).
(Figure 44).
(Figure 42).
Removing the Fuel
Controls System
Maintenance
Adjusting the
Motion-Control Levers
If the motion-control levers do not align horizontally,
adjust the right side motion-control lever.
1. Park the machine on a level surface, lower the
hopper, engage the parking brake, shut off the
engine, and remove the key.
2. Push the motion-control levers down out of the
N -
EUTRAL LOCK
3. Check if the right motion-control lever aligns
horizontally with the left motion-control lever
(Figure 46).
1. Left motion-control lever
2. Right motion-control lever
in the Neutral-lock position
4. To adjust the motion-control levers horizontally,
you must adjust the cam.
5. Release the cushion from the rear of the
machine.
6. Loosen the nut holding the cam
32
position (Figure 46).
Figure 46
3. Check the horizontal
alignment here
4. Right motion-control lever
(Figure
g009436
47).