Scanning Active Time - Datalogic QuickScan QM24 Series Product Reference Manual

References

Scanning Active Time

This setting specifies the amount of time that the reader stays in scan ON state once the state is
entered. The range for this setting is from 1 to 255 seconds in 1-second increments.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the result with leading zeroes to yield three digits. For example: 0 = 000, 5 = 005, 20
= 020, etc.
3. Go to page 79
ming Mode.
4. Scan the bar code: SELECT SCANNING ACTIVE TIME SETTING.
5. Scan the appropriate three digits from the keypad in
the duration which was determined in the steps above. You will hear a two-beep indication
after the last character.
If you make a mistake before the last character, scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the beginning.
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See
Table 39. Scanning Active Time Setting Examples
STEP ACTION
1 Desired Setting
2 Pad leading zero(es)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT SCANNING ACTIVE TIME SETTING
Scan Three Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
256
and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
Table 39
EXAMPLES
1 Second
'0', '0' and '1'
Appendix D,
for some examples of how to set this feature.
90 Sec. (1.5 min.) 180 Sec. (3 min.)
001 090
'0', '9' and '0'
QuickScan™ I QD24XX/QBT24XX/QM24XX
Keypad, that represent
255 Seconds (4.25
min.)
180
'1', '8' and '0' '2', '5' and '5'
255