Ack Character; Nak Character - Datalogic QuickScan QM24 Series Product Reference Manual

RS-232/USB-Com Interfaces

ACK Character

This setting specifies an ASCII character or hex value to be used as the ACK character. ASCII
characters or any hex value from 0 to 0xFF can be selected. See
Setting to previously defined characters such as XON, XOFF, or host commands conflicts with
normal operation of these characters. 8-bit data is not recognized when the option
on page 29
$CR2AC
Select ACK Character Setting

NAK Character

This setting specifies an ASCII character or hex value to be used as the NAK character. ASCII
characters or any hex value from 0 to 0xFF can be selected.
Setting to previously defined characters such as XON, XOFF, or host commands conflicts with
normal operation of these characters. 8-bit data is not recognized when the option
on page 29
$CR2NA
Select NAK Character Setting
Product Reference Guide
has been set as 7 Data Bits.
0x06 'ACK' Character
DEFAULT
has been set as 7 Data Bits.
0x15 'NAK' Character
DEFAULT
Enter/Exit Programming Mode
page 234 for more information.
See page 235 for more information.
Data Bits
Data Bits
35