Driftwood Media Kit Installation - Regency Grandview G800C-1 Manual

installation
Driftwood Media Kit Installation (Part #761-931)
G800C/G800EC
1. Place the media tray over the burner, as shown below.
f i r e - p a r t s . c o m
2. Attach the media tray with two screws, one on the middle-left and
one on the middle-right of the tray, as shown below.
3. Place Log #1 at the back of the firebox, centered as shown below.
The bottom points of the log should touch the media tray, and the
back of the log should touch the back firebox panel.
72 | Grandview G800C-1 Gas Fireplace
®
920-400
DRIFTWOOD MEDIA TRAY INSTALLATION (PART #761-931)
Page 1
4. Add the three supplied stones to the tray in the locations shown.
The stones must not cover the burner porting.
5. Add the supplied grey and black ember media (1.5 lbs total) and
spread it across the tray and around the stones in an even layer.
IMPORTANT:
1. Ensure that at least 50% of the gas burner porting remains
uncovered. Do not cover the pilot area or place any embers
on the pilot cover.
2. Ensure there is no ember media underneath the three stones
- they must sit directly on the media tray.
06.24.21