Crystal Tray Installation - Regency Grandview G800C-1 Manual

G800EC/G800C
Crystal Tray Installation (Part #761-937)
Note: The optional brick, steel, or enamel panels must be
installed prior to the crystal tray.
1. Place the crystal tray over the burner, as shown below.
f i r e - p a r t s . c o m
2. Attach the crystal tray with two screws, one on the middle
left and another on the middle right of the tray, as shown
below.
920-199

CRYSTAL TRAY INSTALLATION

3. Add 7 lbs of crystal media and spread it across the tray in
one even layer. Important: ensure that at least 50% of the
gas burner porting remains uncovered. Do not cover
the pilot area.
PILOT
4. If using volcanic stones as additional media, add a maximum
of 13, as shown below. Important: Volcanic stones should
not cover any of the gas burner porting or pilot areas.
5. To remove the crystal tray, reverse the steps above.
Page 1
installation
BURNER PORTING
Grandview G800C-1 Gas Fireplace |
®
71
12.03.19