Conversion From Ng To Lp Using Sit 885 Proflame Gas Valve - Regency Grandview G800C-1 Manual

Conversion from NG to LP (Part #761-977)
LP CONVERSION
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
Each Kit contains one LP Conversion Kit
Conversion Kit #761-977 Contains:
Qty. Part # Description
1 904-947 Burner Orifice #53 LP
(PO5-12)
1 904-529 5/32" Allen Key
1 918-590 Decal "Converted
to LPG"
1 908-528 Red "LP" label
1 910-037 L P Injector (Pilot
Orifice)
1 920-183 Instruction Sheet
Installation of LP
Conversion Kit:
1. Shut off the gas and electrical supply.
f i r e - p a r t s . c o m
2. Remove the safety screen*.
3. Remove the glass door*.
4. Remove the logs, glass, and any other
media*.
5. Remove the two log supports* and log
grate assembly by removing 2 screws
and sliding the tray forward to remove.
*(See specific instructions in unit manual.)
Diagram 1: Remove the left and right screws.
6. Remove three screws then remove the
burner assembly.
Diagram 2: Slide burner assembly to the
right—then remove.
920-183
IF IN DOUBT DO NOT DO THIS CONVERSION !
7. Remove the pilot retainer clip below the
pilot cap.
Pilot retainer clip
8. Pull off the pilot cap to expose the pilot
orifice.
9. Unscrew the pilot orifice with the Allen key;
then replace with the LPG pilot orifice,
provided in the kit.
10. Re-install pilot cap and pilot retainer clip.
11. Remove burner orifice with a 3/8"
12. Reinstall new burner orifice LPG
13. Turn control knob to the "OFF position.
14) Remove the
Fig.2
1
G800C
wrench. Use another wrench to hold on
to the elbow behind the orifice. Discard
orifice.
stamped #53 and tighten.
Locate the Hi/Lo knob on the gas valve.
See diagram below.
black protection
cap by hand from
the hi-low knob
(Fig.1).
Fig. 1
15) Insert a 5/32" or 4mm
Allen wrench into the
hexagonal key-way
of the screw (Fig.
2), rotate it counter-
clockwise until it is
free and extract it.
Installer Notice:
These instructions must
remain with the appliance.
Grandview G800C-1 Gas Fireplace |
®
11.02.20
installation
63