Venting Arrangements - Horizontal Termination - Rigid Pipe And Direct Vent System (Flex) - Regency Grandview G800C-1 Manual

Venting Arrangements - Horizontal Termination - Rigid Pipe and Direct Vent System (Flex)

(Propane & Natural Gas)
The diagram shows all allowable combinations of vertical runs with horizontal terminations, using one 90
Note: Must use optional rigid pipe adaptor (Part # 510-994) when using Rigid Pipe venting systems.
0 0
1 1 8 8
1 1 6 6
1 1 4 4
f i r e - p a r t s . c o m
1 1 2 2
1 1 0 0
8 8
6 6
4 4
2 2
0 0
•
Maintain clearances to combustibles.
• Horizontal vent must be supported every 3 feet.
• Firestops are required at each floor level and whenever passing through a wall.
Horizontal (Feet)
4 4
2 2 6 6
Set #2 (1-3/4")
Set #1-2" open
44" (1118mm)
Minimum
Height
Requirement
8 8
1 1 0 0 1 1 2 2
Set #0-Fully Open
Note: FPI Direct Vent Flex System Part
elbow (two 45 elbows equal one 90
o o
1 1 4 4 1 1 6 6
1 1 8 8
All Rigid Pipe Systems
4" inner diameter
6-5/8" outer diameter
FPI Flex Vent
4" inner diameter
6-7/8" outer diameter
A vent guard should be used
whenever the termination is lower
than the specified minimum or as
per local codes.
#:946-513 (2 foot), 946-515 (4 foot)
and 946-516 (10 foot) are only ap-
proved for horizontal terminations.
Grandview G800C-1 Gas Fireplace |
®
installation
elbow).
o
2 2 0 0
51