Table of Contents
Advertisement
OPTIONAL ON/OFF REMOTE KIT INSTALLATION
Optional On/Off Remote Kit Installation (Part # 761-976)
An optional on/off remote and receiver may be installed in the unit.
1. Connect the supplied speed control switch and unit receptacle to
the 120V mains power supply by following the wiring diagram as
shown.
2. Install 4 x AA batteries into the remote receiver and 3 x AAA
batteries into the remote control.
3. Locate the black wire running from the valve to the unit on/off
switch. Unclip the wire holder clip and remove the black wire from
the clip.
f i r e - p a r t s . c o m
4. Break the connection between the inline wire connectors on the
black wire.
920-192
5. Connect the two connectors on the black wire to the two wires
from the remote receiver, as shown.
6. Put the receiver in position in the holder bracket beneath the
firebox, to the right of the DC Sparker and Fan Speed Control
Module (if installed). Secure with supplied velcro strips.
7. Tidy the wires together and secure wires back into the wire hold-
er clip.
NOTE: The remote receiver may be installed as a wall
mounted switch if required. A wall mount cover
plate is provided with the receiver. See instruc-
tions in this manual for Installing an Optional Wall
Switch of Thermostat.
1
installation
G800C
Grandview
G800C-1 Gas Fireplace |
®
11.25.19
83
Advertisement
Table of Contents
