Outside Finish Installation (Non Cool Wall) - Clearances - Regency Grandview G800C-1 Manual

installation

Outside Finish Installation (Non Cool Wall) - Clearances

The clearances listed below are minimum distances unless otherwise stated.
A major cause of chimney related fires is failure to maintain required clearances (air space) to combustible materials. It is of the greatest importance
that this fireplace and vent system be installed only in accordance with these instructions.
Caution Requirements
The top, back and sides of the fireplace are defined by
standoffs. The metal ends of the standoff may NOT be
recessed into combustible construction.
Outside Finish Clearance Requirements
Clearance:
A: Mantel Height (min.)
B: Sidewall 25" (635 mm) one side only
C: Ceiling
D: Mantel Depth (max.)
E: Alcove Width
f i r e - p a r t s . c o m
F: Alcove Depth
Notes:
C
D
E
F
Alcove
32 | Grandview G800C-1 Gas Fireplace
®
Dimension
10" (254 mm) Top of Fireplace Opening
Side of Fireplace Opening
36-1/2" (927 mm) Top of Fireplace Opening
12" (305 mm) Top of Fireplace Opening
84" (2134 mm) Wall to Wall (Minimum)
36" (914 mm) Front to Back Wall (Maximum)
0" No Hearth Required
Fire hazard is an extreme risk
if these clearances (air space) to combustible
materials are not adhered to. It is of greatest
importance that this fireplace and vent system be
installed only in accordance with these instructions.
Measured From:
Minimum Vent Clearances
to Combustibles
Horizontal Top
Horizontal Side
Horizontal Bottom
Vertical Vent
WARNING
2" (51 mm)
1-1/2 " (38 mm)
1-1/2" (38 mm)
1-1/2" (38 mm)