Table of Contents
Advertisement
installation
G600C/G600EC
Driftwood Tray Installation
Read the instructions below carefully. If the logs are broken
do not use until they are replaced. Broken logs can interfere
with pilot operation.
Improper positioning of the logs may create carbon buildup
and can alter the unit's performance which is not covered
under warranty.
The Driftwood log set kit # 776-931 contain the following:
Logs 1 to 5
Stones ( 2 pieces)
Embers Andiron Black 0.3lb
Embers Ashen 0.8lb
1. Place the driftwood media tray over the burner, as shown below.
2. Attach the driftwood media tray with two screws, one on the mid-
dle-left and one on the middle-right of the tray, as shown below.
3. Add two stones to the tray prior to adding ember media in the
locations shown. The stones must not cover the burner porting.
4. Add the supplied ember media (1.1lbs total) and spread it across
the tray and around two stones in one even layer.
74 | Grandview
920-379
G600C Gas Fireplace
®
DRIFTWOOD MEDIA TRAY INSTALLATION
IMPORTANT:
1. Ensure that at least 50% of the gas burner porting remains
uncovered. Do not cover the pilot area or place any embers
on the pilot cover.
2. Ensure there is no ember media underneath the two stones
- they must sit directly on the media tray.
5. Place Log #1 against the back of the firebox, centered as shown.
Make sure Log #1 is sitting on the tray.
6. Place Log #2 on the lefthand side of the tray as shown. Ensure the
left pin of Log #1 fits into the hole on the underside of Log #2. Make
sure Log #2 is supported by the tray (see encircled).
2
7. Place Log #3 in the front-right area of the tray as shown.
Page 1
Pilot area
1
1
3
07.29.21
Advertisement
Table of Contents
