Table of Contents
Advertisement
installation
G800C
Fan Install After Unit Installation
The fan may be installed after the unit has been installed and
finished. Ensure the unit is turned off and has cooled to room
temperature.
1. Remove the screen, glass door, and bottom cover panel (see
manual for instructions).
2. Remove any media already installed (logs, glass ,etc.) and set
aside.
3. Remove the log grate if installed.
4. Remove the burner by removing 3 screws.
5. Remove the ember media tray with 2 screws.
f i r e - p a r t s . c o m
6. Remove the fan access panel by removing 8 screws.
7. Connect the 2 fan ground wires to the unit ground lug and
secure the fan speed control module with 2 screws (see steps
4-5 from previous page). Tidy ground wires with provided
plastic wire clip.
8. Install fan onto pins at the back right of the unit floor. Push
down on the front of the fan bracket to raise the back of the fan
assembly onto the pins.
80 | Grandview
G800C-1 Gas Fireplace
®
FAN INSTALL AFTER UNIT INSTALLATION
9. Attach thermodisc cage to the bracket on the underside of the
fan access panel.
10. Reinstall all removed components by reversing steps 1-6.
11. Plug fan power cord into unit electrical outlet (see step 8 from
previous page)
TO REMOVE THE FAN
1. Shut the power off.
2. Reverse the above instructions.
Note: The bearings are lubricated for life. Do not lubricate
them. Make sure you vacuum the fan area on a regular
basis.
IMPORTANT:
These fans collect a lot of dust from within your home. Ensure
you maintain these fan motors on a regular basis by vacuum-
ing our the fan blades and housing using a soft brush nozzle.
Advertisement
Table of Contents
