Installing The Os; Configure The Preinstalled Os - Oracle SPARC T8-4 Installation Manual

After the system console finishes its low-level system diagnostics, the SP initializes and runs a
suite of higher level diagnostics. When you access the SP using a device connected to the SER
MGT port, you see the output of the Oracle ILOM diagnostics.
By default, the SP configures the NET MGT port automatically, retrieving network
configuration settings using DHCP and allowing connections using SSH.
For a more detailed discussion on configuring the system console and connecting terminals,
refer to the administration guide for your server.
Related Information
"Configure the Preinstalled OS" on page 71
■
"Reach a State to Install a Fresh OS (Oracle ILOM CLI)" on page 72
■
"Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)" on page 74
■
"Assign a Static IP Address to the NET MGT Port" on page 79
■
SPARC T8 Series Servers Administration Guide
■
Oracle ILOM documentation
■

Installing the OS

Use these topics to either configure the preinstalled OS or use an alternative OS.
"Configure the Preinstalled OS" on page 71
■
"Reach a State to Install a Fresh OS (Oracle ILOM CLI)" on page 72
■
"Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)" on page 74
■
Related Information
"Oracle Solaris OS Configuration Parameters" on page 76
■

Configure the Preinstalled OS

Determine which OS you will use.
1.
If you plan to use the preinstalled OS, proceed to step 2.
■
Powering On the Server for the First Time
Installing the OS
71