Table of Contents
Advertisement
To set, confirm, verify, disable or delete a user' s password, follow the
procedures described in the section " Supervisor Password" . If you for-
get your password, refer to the procedure described in the same sec-
tion.
IDE HDD Auto Detection
This option detects the hard disk parameters for the hard disk drives
installed in your system. Highlight this option and press <Enter>. A
screen similar to the one on the next page will appear.
HARD DISKS
Primary Master:
OPTIONS
2 (Y)
1
3
Note: Some OS (like SCO-UNIX) must be "NORMAL" for installation
Enter your choice, and press <Enter> to accept the parameters or press
<Esc> to abort. The parameters of the hard disk will be displayed in the
Standard CMOS Setup.
Hard Drive Mode
The system board supports three HDD modes: Normal, LBA and Large.
If your hard disk drive does not support LBA mode, the " LBA" option will
not be displayed. If your HDD has 1024 or fewer cylinders, the " Large"
option will not be displayed. If your hard drive is larger than 2.1GB, be
sure that your operating system supports it or you may need to create
separate partitions.
ROM PCI/ISA BIOS
CMOS SETUP UTILITY
AWARD SOFTWARE, INC.
TYPE SIZE CYLS HEAD RECOMP LANDZ SECTOR MODE
Select Primary Master Option (N=Skip): N
SIZE CYLS HEAD
RECOMP LANDZ SECTOR
853
827
32
0
853
1654
16
65535
853
827
32
65536
ESC: Skip
MODE
1653
63
LBA
1653
63
Normal
1653
63
Large
55
Advertisement
Table of Contents
