DFI 586ITX User Manual page 53

UART 2 Mode
The 586ITX system board supports
IrDA function for wireless connec-
tivity between your computer and
peripheral devices. To use the IrDA
function, follow the steps below.
1. Connect your IrDA cable to
connector CN4 of the 586ITX
system board.
2. Set " UART 2 Mode" to the type
of IrDA standard supported by
your IrDA peripheral/device.
You may not use IrDA (CN4) and the COM 2 serial port (CN3) at the
same time. If you are using the COM 2 serial port, set " UART 2 Mode"
to Standard.
Standard Uses the COM 2 serial port.
IrDA HP mode IrDA.
ASK-IR SHARP mode IrDA.
Onboard Parallel Port
Selects the I/O address and IRQ for the onboard parallel port.
378H/IRQ7
3BCH/IRQ7
278H/IRQ5
Disables the onboard parallel port.
Disabled
Parallel Port Mode
Normal Selects the parallel port mode according to the type of
EPP1.7+SPP printer device connected to your onboard parallel port.
ECP+EPP1.7
SPP
EPP1.9++SPP
ECP
ECP+EPP1.9
53