Table of Contents
Advertisement
IDE HDD Auto Detection
This option detects the hard disk parameters for the hard disk drives
installed in your system. Highlight this option and press <Enter>. A
screen similar to the one below will appear.
HARD DISKS
TYPE SIZE CYLS HEAD RECOMP LANDZ SECTOR MODE
Primary Master:
OPTIONS
SIZE CYLS HEAD
2 (Y)
853
1
853
3
853
Note: Some OS (like SCO-UNIX) must be "NORMAL" for installation
Enter your choice, and press <Enter> to accept the parameters or press
<Esc> to abort. The parameters of the hard disk will be displayed in the
Standard CMOS Setup.
Hard Drive Mode
The system board supports three HDD modes: Normal, LBA and Large.
If your hard disk drive does not support LBA mode, the " LBA" option will
not be displayed. If your HDD has 1024 or fewer cylinders, the " Large"
option will not be displayed. If your hard drive is larger than 2.1GB, be
sure that your operating system supports it or you may need to create
separate partitions.
Normal Mode
The Normal mode is the generic access mode in which neither the
BIOS nor the IDE controller will make any transformations during hard-
drive access.
ROM PCI/ISA BIOS
CMOS SETUP UTILITY
AWARD SOFTWARE, INC.
Select Primary Master Option (N=Skip): N
RECOMP LANDZ SECTOR
827
32
0
1653
1654
16
65535
1653
827
32
65536
1653
ESC: Skip
MODE
63
LBA
63
Normal
63
Large
39
Advertisement
Table of Contents
