DFI 586ITX User Manual page 45

Power Management : User Define
PM Control by APM : Yes
Video Off Method : V/H SYNC+Blank
Video Off After : Standby
Doze Mode : Disable
Standby Mode : Disable
Suspend Mode : Disable
HDD Power Down : Disable
Throttle Duty Cycle : 62.5%
VGA Active Monitor : Enabled
Soft-Off by PWR-BTTN : Delay 4 Sec.
** Break Event From Suspend **
IRQ 8 Clock Event : Disabled
Power Management
This category allows you to select the type (or degree) of power saving
by changing the length of idle time that elapses before each of the
following modes are activated: Doze Mode, Standby Mode, and Sus-
pend Mode.
Disable No power management. Disables the Doze, Standby and
(default) Suspend modes.
Min. Power Minimum power management. Doze Mode = 1 hr., Standby
Saving Mode = 1 hr., and Suspend Mode = 1 hr.
Max. Power Maximum power management. Doze Mode = 1 min.,
Saving Standby Mode = 1 min., and Suspend Mode = 1 min.
User Allows you to set each mode individually. When enabled,
Defined each option ranges from 1 min. to 1 hr.
PM Control by APM
Yes An Advanced Power Management device will be activated to
enhance the Max. Power Saving mode and stop the CPU' s
internal clock. Use this option in Windows 95. (default)
N o The system BIOS will ignore APM when initiating the Power
Management mode.
ROM PCI/ISA BIOS
POWER MANAGEMENT SETUP
AWARD SOFTWARE, INC.
** Reload Global Timer Events **
IRQ [3-7, 9-15], NMI
Primary IDE 0
Primary IDE 1
Secondary IDE 0
Secondary IDE 1
Floppy Disk
Serial Port
Parallel Port
↑ ↓ → ←
ESC : Quit
F1 : Help
PU/PD/+/-
F5 : Old Values (Shift) F2
F6 : Load Fail-Safe Settings
F7
: Load Optimal Settings
: Enabled
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
: Enabled
: Disabled
: Select Item
: Modify
: Color
45