User Password; Ide Hdd Auto Detection - DFI 586IHX User Manual

Use the arrow keys to highlight the " Supervisor Password" option and
press <Enter>. The message below will appear.
Type in the password. You are limited to eight characters. When done,
the message below will appear:
You are being asked to verify the password. Type in exactly the same
password. If you type in a wrong password, you will be prompted to
enter the correct password again.
To delete or disable the password function, highlight " Supervisor Pass-
word" and press <Enter>, instead of typing in a new password. Press
the <Esc> key to return to the main menu.

User Password

If you want another user to have access only to your system but not to
setup, set a user' s password with the " System" option selected in the
BIOS Features Setup.
If you want a user to enter a password when trying to access setup, set
a user' s password with the " Setup" option selected in the BIOS Fea-
tures Setup. Using a user' s password to enter Setup allows a user to
access only the " User Password" option that appears on the main
screen. Access to all other options is denied.
To set, confirm, verify, disable or delete a user' s password, follow the
procedures described in the section " Supervisor Password" . If you for-
get your password, refer to the procedure described in the same
section.

IDE HDD Auto Detection

This option detects the hard disk parameters for the hard disk drives
installed in your system. Highlight this option and press <Enter>. A
screen similar to the one on the next page will appear.
Enter Password:
Confirm Password:
47