Configuring The Output Format - IAI GO-5100M-USB User Manual

Step 5: Changing the Camera Settings
This section explains how to change settings by describing the procedure for changing the
output format as an example.

Configuring the Output Format

Configure the size, position, and pixel format of the images to be acquired.
The factory settings are as follows. Change the settings as necessary.
Factory default values
ImageFormatControl
* You can specify the image acquisition area. For details, see "ROI (Regional Scanning Function)".
1
Configuring the [Width] of［ImageFormatControl］
By selecting the item of [Width], you can change the value as shown below.
Device Control
Visibility
Beginner
DeviceControl
DeviceVendorName
DeviceModelName
DeviceManufactureInfo
DeviceVersion
DeviceFirmwareVersion
DeviceID
DeviceUserID
DeviceTemperature
DeviceReset
ImageFormatControl
WidthMax
HeightMax
Width
Height
Offset X
Offset Y
PixelFormat
TestPattern
Acquisition Control
AcquisitionMode
AcquisitionStart
AcquisitionStop
AcquisitionFrameCount
AcquisitionFrameRate
Note
Depending on the setting item, you need to change visibility.
Please switch visibility (Beginner / Expert / Guru) as necessary.
Item
Width
Height
OffsetX (horizontal position)
OffsetY (vertical position)
PixelFormat
JAI Corporation
GO-5100C-USB
See the possibilities
XXXXX
XXXXX
XXXXX
JAI_DEMO
XXXXX
ー
2464
2056
2464
2056
0
0
BayerRG8
Off
Continuous
ー
ー
1
74.0192
— 16 —
GO-5100M-USB / GO-5100C-USB
2464
2056
0
0
BayerRG8
×
Default value