IAI GO-5100M-USB User Manual page 52

Item
Sequencer Command Index
Sequencer Set Start
Sequencer Reset
j) Chunk Data Control
Chunk Mode Active
Chunk Selector
Chunk Enable
k) Transport Layer Control
Payload Size
Device Tap Geometry
l) JAI Custom Control Pulse
Generators
Clock Pre-scaler
Pulse Generator Clock (MHz)
Pulse Generator Selector
Setting range
—
—
—
True, False
Chunk Image,
Chunk Offset X,
Chunk Offset Y,
Chunk Width,
Chunk Height,
Chunk Pixel Format,
Chunk Timestamp,
Chunk Line Status All,
Chunk Exposure time (us),
Chunk Gain All,
Chunk Gain Red,
Chunk Gain Blue,
Chunk Black Level All,
Chunk Sequencer Set
Active,
Chunk Frame Trigger
Counter,
Chunk Exposure Start
Counter,
Chunk Frame Start Counter,
Chunk Frame Transfer End
Counter,
Chunk Line Status All On
FVAL Start,
Chunk Device Temperature,
Chunk Device Serial
Number,
Chunk Device User ID
True, False
—
Geometry_1X1_1Y
1 to 4096
0.018127 to 74.25
Pulse Generator 0
— 52 —
GO-5100M-USB / GO-5100C-USB
Default value
1 Set this to change the Sequencer Index.
(Enabled only for Command Sequencer.)
1 Set the index number that is used when
executing [Sequencer Reset] in [Trigger
Sequencer] mode or [Command
Sequencer] mode.
— Reset the current index number to the
number configured in [Sequencer Set
Start].
Configure Chunk Data function settings.
True Enable/disable the Chunk Data function.
Image Select the information you want added to
the image data.
— Select whether to add the information to
the image data.
Default value: [Chunk Image] only "True"
Display information on transport layer
control.
5065984 Display the payload size.
Geometry_1X1_ Set the transmission method for each time
1Y images are transmitted from the device
(TAP structure).
Configure pulse generator settings.
165 Set the division value for the prescaler
(12-bit) using the pixel clock as the base
clock.
0.45 Set the clock used for the pulse
generator.
This value is calculated based on the
Clock Pre-Scaler value.
Pulse Generator Select the pulse generator.
0
Description