Zones Installed; Zones Enabled; Zones Disabled; Zone Type - Honeywell Fire-Lite Alarms MS-9050UD Manual

Programming
ZONE SETUP

1=ZONES INSTALLED

2=ZONES ENABLED

3=ZONES DISABLED

Zone Setup Screen #2
ZONE SETUP
1=ZONE TYPES
2=ZONES AVAILABLE
3=FUTURE
Zone Setup Screen #3
86
3.6.3.4 Zones Installed
Pressing 1 for Zones Installed, while viewing Zone Setup Screen #2, will display a screen
similar to the following:
ZONES INSTALLED
00 01 02 03 04 05
This display will show all of the zones that have been programmed into the control panel.
3.6.3.5 Zones Enabled
Pressing 2 for Zones Enabled, while viewing Zone Setup Screen #2, will display a screen
similar to the following:
ZONES ENABLED
00 01 02 04 05 06 07
08 09 10 11 12 13 14
15 16 17 18 19
This display will show all of the zones that are enabled in the control panel.
3.6.3.6 Zones Disabled
Pressing 3 for Zones Disabled, while viewing Zone Setup Screen #2, will display a screen
similar to the following:
ZONES DISABLED
03
This display will show all of the zones that are disabled in the control panel.

3.6.3.7 Zone Type

Zone Types must be programmed only if a DACT, programmed for zone reporting, is installed
on the control panel. Pressing 1 for Zone Types, while viewing Zone Setup Screen #3, will
display a screen similar to the following:
ZONE TYPE PROG
1=Z00
2=Z01
3=Z02
Zones Installed Screen
Zones Enabled Screen
Zones Disabled Screen
MONITOR
MONITOR
MONITOR
Zones Installed Screen
MS-9050UD PN 52413:C 01/23/08