Relays - Honeywell Fire-Lite Alarms MS-9050UD Manual

SYSTEM SETUP
1=TIMERS
2=NAC

3=RELAYS

System Setup Screen #2
RELAY
1=ALARM
2=SUPERVISORY
3=SUPERVISORY AR
Relay Screen #1
RELAY
1=TROUBLE
2=COMM FAIL
3=PROCESS MON
Relay Screen #2
MS-9050UD PN 52413:C 01/23/08
3.6.5.6 Relays
Pressing 3 while viewing System Setup Screen #2 will allow the programmer to configure two
main circuit board Form-C relays from the following screen:
1=RELAY 1
2=RELAY 2
3=RELAY 3
To program Relay 1 or Relay 3, press the number corresponding to the selected relay. Note that
Relay 2 is fixed as a Trouble relay. Selecting Relay 2 will have no effect on its programming.
The following screen will appear for each relay to be programmed:
1=TYPE
Pressing 1 for Type while viewing the Relay Screen will cause the following screens to be
displayed:
While viewing the selected screen, press the number corresponding to the desired relay type to
program the main circuit board relay. The choice will be stored in memory and the display will
return to the Relay Type Screen which will show the programmed type choice. Press the
Escape key to return to the Relays Selection Screen and repeat the preceding procedure for the
remaining relays.
Notes:
1. AR (AutoResettable) in SUPERVISORY AR and PROCMON AR means that a relay with the
Supervisory and/or Process Monitor type code, when activated, will automatically reset
when the corresponding condition is cleared.
2. A relay programmed with the Silenceable Alarm type will activate upon any alarm and reset
when the alarm is cleared and/or when the Alarm Silence button is pressed.
RELAYS
Relays Selection Screen
RELAY #
ALARM
Relay Type Screen
RELAY
1=PROCESS MON AR
2=AC LOSS
3=HAZARD
Relay Screen #3
RELAY
1=MEDICAL
2=SILENCEABLE ALARM
Relay Screen #4
Programming
101