Honeywell Fire-Lite Alarms MS-9050UD Manual page 107

Pressing 1 for Type will display the following screens:
Press the number corresponding to the module type that is installed with the selected address.
Note: If the module type selected is the ANN-80 or ANN-S/PG or if Not Installed is selected, the
ANN-BUS Address Screen shown on the previous page will be displayed following the module
selection. The options selected for each of these modules will be the same for all modules of
the same type (refer to "ANN-S/PG (Print) Options Screen" on page 116 and "ANN-80
Options Screen" on page 117).
If ANN-I/O, ANN-LED or ANN-RLY is the selected module type, the following ANN-BUS
Address Screen will be displayed:
Since the options for each of these module types can be individually set, pressing 2 for Module
Options, while viewing the ANN-BUS Address Screen will display the available options as
described below.
ANN-I/O Options Screen
Pressing 2 for Module Options while viewing ANN-BUS Address screen when the ANN-I/O
option is selected will display the following screen:
MS-9050UD PN 52413:C 01/23/08
ANN-BUS MODULE TYPE
1=NOT INSTALLED
2=ANN-80 MODULE
3=ANN-I/O MODULE
Module Type Screen #1
ANN-BUS MODULE TYPE
1=ANN-S/PG MODULE
2=ANN-LED MODULE
3=ANN-RLY MODULE
Module Type Screen #2
ANN-BUS MODULES
ANN-BUS ADDRESS #
1=TYPE
2=MODULE OPTIONS
ANN-BUS Address Screen
ANN-I/O ADDR #
1=POINT/ZONE
2=RANGE
ACTIVE LEDS ONLY
ANN-I/O Address Screen
ANN-I/O
ZONE
00-19
Programming
107