Working With Measurements; Laying Out A Spot; Laying Out A Measurement Area - FLIR ThermaCAM EX320 User Manual

8 – Tutorials
8.3
8.3.1
➲ The camera requires a warm-up time of 5 minutes before accurate measurements
can be expected.
Step
1
2
3
4
5
8.3.2
➲ The camera needs a warm-up time of 5 minutes before accurate measurements
can be expected.
8
Step
1
2
3
4
44

Working with measurements

Laying out a spot

Action
Press MENU/YES to display the vertical menu bar.
Point to Meas. mode on the vertical menu bar and press MENU/YES.
Select Spot in the Meas. mode dialog box and press MENU/YES.
Press SEL until small brackets appear around the spot. You can now move the
spot by pressing the navigation pad left/right or up/down.
To add additional spots, repeat step 1–4. A maximum number of three spots can
be added.
The temperature will be displayed in the top right corner of the LCD.

Laying out a measurement area

Action
Press MENU/YES to display the vertical menu bar.
Point to Meas. mode on the vertical menu bar and press MENU/YES.
Select Area max, Area min or Area avg in the Meas. mode dialog box and press
MENU/YES.
The temperature will be displayed in the top right corner of the LCD.
Publ. No. 1558146 Rev. a156 – ENGLISH (EN) – February 28, 2006