Connecting The Plc For Ltsi Operation - Novexx Solutions 64 Series Technical Manual

08/10 Rev. 5.05-01
Connecting the PLC for LTSI
operation
Also refer to section
64-xx on page 10.
The cable harness fitted earlier consists of
three cables, labeled VENT, SENS and
MOTOR (fig. 1). Two connectors on the
PLC board are also labeled VENT and
SENS.
1. Connect the VENT (5) and SENS (6)
cables, which are part of the cable har-
ness, to the sockets on the PLC board that
bear the same names (fig. 2).
2. Connect the MOTOR (7) cable, which is
part of the cable harness, to the output
stage board (fig. 2).
The plugs (1), (2) and (3) are located on
two of the cables that are already plugged
into the PLC board (fig. 3).
Continued overleaf.
TECHNICAL MANUAL
Connection Diagram
64-xx
1
2
3
8
Mounting the PLC