Novexx Solutions 64 Series Technical Manual page 5

08/10 Rev. 5.05-01
4. Remove the cable clamp (1) from the prin-
ter bottom (by means of a screwdriver).
Fig. 4 shows the two fixing holes (2) to
which the PLC module is screwed. The
frontal hole was beforehand used to fix the
power supply. The rear hole already bears
a screw which can be used to fix the PLC
module.
5. Unscrew the rear fixing screw out of the
printer bottom.
6. Pull at the wiring harness (3) as illustrated
to make room for the insertion of the PLC
module (fig. 5).
7. Turn the PLC module carefully over the
wiring harness into the printer (fig. 6).
The carrier plate of the PLC module must
have contact to both, printer bottom and
partitioning wall!
Continued overleaf.
TECHNICAL MANUAL
64-xx
3
4
5
6
5
Mounting the PLC