Novexx Solutions 64 Series Technical Manual page 6

08/10 Rev. 5.05-01
8. Right now is the best moment to connect
the PLC module to the USI board!
See paragraph Connecting the PLC for
LTP/LTPV operation
ly paragraph Connecting the PLC for LTSI
operation on page 8.
9. Put the power supply in its initial position
and fix it at the angled plate (fig. 7).
Reconnect the cables you unplugged
before.
Order of the parts which are fixed by the
screw: cable clamp, PLC module, angled
plate (top down).
10. Screw the rear fixing screw into the PLC
module plate.
To do so, hold the screw with some flat
nose pliers and turn it in using the 4 mm al-
len key with ball head!
11. Tighten all the fixing screws of power sup-
ply and PLC module.
12. Connect the PLC module as it is shown in
the following paragraphs.
13. Fix the cables by means of the cable
clamps (fig. 8).
14. Reassemble the housing parts.
TECHNICAL MANUAL
on page 7 respective-
64-xx
7
8
6
Mounting the PLC