Assembly; Safety - Novexx Solutions 64 Series Technical Manual

08/10 Rev. 5.05-01

Assembly

Safety

•
•
•
CAUTION! - Protect the electronic components against damage from electro-
static discharge.
TECHNICAL MANUAL
WARNING!
This unit operates at mains voltage! Coming into contact with electrically
live components can cause potentially lethal electrical shocks and burns.
Only authorised technicians are permitted to remove any parts of the
enclosure.
Before removing any parts of the enclosure, switch off the device and re-
move the mains plug.
If, after removing the enclosure, the device has to be switched on for repair
and testing purposes, observe the following:
Never touch electrically live components. This also applies to low-voltage
components.
Only operate the unit when the enclosure is properly installed.
Never open the enclosure of the power supply. If the power supply is de-
fective, you must replace the entire power supply.
Ensure that the electrical system is functioning flawlessly.
Test the electrical system on a regular basis.
Retighten any loosened connections.
Immediately replace any damaged lines.
After assembling, check the printer according to the regulations relevant in
your country.
Wear protective ESD gear.
Place the device on an earthed pad before opening it.
64-xx
3
Mounting the PLC