Fitting The Cover Plate - ABB A140-H56 Operation Manual

Operation Manual / A130-H.. - A140-H..
11 Taking out of operation at short notice
11.4

Fitting the cover plate

Remove turbocharger (see chapter Removal and installation [➙ 29]).

Gas outlet casing removed

Fit the turbine casing with the gas outlet casing into the gas pipe again.

Attach the cover plate (see following section).

Gas outlet casing not removed

Fit the turbine casing into the gas pipe and on the gas outlet casing again.

Attach the cover plate (see following section).

Figure 48
Make sure that the oil connections in the bracket are equipped with gaskets.

Close the opening in the turbine casing (51000) with the cover plate (A).

Thoroughly clean the fastening strips (51002) before assembly. Coat the threads of the

studs (51006) with high-temperature grease.
Fasten the cover plate (A) on the turbine casing (51000) with fastening strips (51002), Ver-

busripp washers (51003) and nuts (51007) and screw it onto the bracket.
© Copyright 2013 ABB. All rights reserved. HZTL2414_EN
Page 107 / 115
Revision B
March 2013