ABB A140-H56 Operation Manual page 86

Operation Manual / A130-H.. - A140-H..
10 Disassembly and assembly
Oil orifice
When disassembling the turbocharger, a fitted oil orifice must not be removed.

Tightening torques for components of the turbocharger
The specified tightening torques of the screw fittings must be observed (Table of tightening
torques [➙ 103]).
Tightening torques for assembly devices from ABB Turbo Systems
Unless described otherwise, the screws and nuts of the assembly devices must be tightened
so they rest firmly against the surface.
Definition of terms
Suspension point

Defined loading point on a component or an assembly (blind hole thread, eyelet, lug).
Assembly device

Devices that are fitted on the turbocharger in order to obtain a suspension point. Assembly
devices are specially constructed and designed for the defined use; they are not trading
goods. Use assembly devices only for the described applications.
Lifting gear

Equipment for the lifting and transporting of loads (ropes, chain block, crane). Lifting gear
is not supplied by ABB Turbo Systems.
Swivel lifting eyes to be used
Two swivel lifting eyes are required for the safe lifting of loads, which are not supplied by
ABB Turbo Systems.
Swivel lifting eyes
Table 28
© Copyright 2013 ABB. All rights reserved.
Product Thread
M
A130 M10 17 mm
A135 M10 17 mm
A140 M12 21 mm
HZTL2414_EN
Page 84 / 115
Length Minimum load
L limit
100 kg
150 kg
250 kg
Revision B
Number
2
2
2
March 2013