Operation Manual / A130-H.. - A140-H..
10
Disassembly and assembly
Axial force of the press-off tool
A high axial force can be generated with the press-off tool. If this tool is
handled improperly (pressing off with too much force on one side), this may
CAUTION
result in damage to the rotor.
Use the tool on both sides alternatingly and make sure not to press off too
hard on either side.
Removing the nozzle ring
Figure 37
Place the fastening strips (51002) under the nozzle ring.
Pull out the nozzle ring (56001) with the two extraction devices (90070) and the service
support base (90012).
Remove the labyrinth sealing ring (56005).
Remove the burst ring (57210).
© Copyright 2013 ABB. All rights reserved.
HZTL2414_EN
Page 94 / 115
Revision B
March 2013