Ce Conformity - ABB A140-H56 Operation Manual

Operation Manual / A130-H.. - A140-H..
3 Introduction
Explanations of the rating plate
The recommended replacement intervals and the corresponding operating limits are jointly
defined with the enginebuilder. This information is specific to the system.
Operation above the indicated values n
replacement intervals. In such a case, we recommend that you contact the nearest official
service station of ABB Turbo Systems.
n , t normally apply only when running at overload (110 %) during trials on the engine
Mmax Mmax
test bed. These limit values can also be permitted during operation for special applications.
Operation above n
Mmax
Non-observance of the recommended replacement intervals increases the risk of unpredictab-
le component failures.
Locations of the rating plates
Figure 12
One rating plate (1) each is attached on the left and the right side of the turbocharger bearing
casing.
3.7

CE conformity

Information
ABB turbochargers comply with the Machinery Directive 2006/42/EC and are incomplete ma-
chines as defined by Article 2 g.
© Copyright 2013 ABB. All rights reserved.
, t
Bmax
and t is not permitted.
Mmax
can considerably shorten the recommended
Bmax
HZTL2414_EN
Page 27 / 115
Revision B
March 2013