Disassembly And Assembly; Introduction - ABB A140-H56 Operation Manual

Operation Manual / A130-H.. - A140-H..
10

Disassembly and assembly

10 Disassembly and assembly
10.1

Introduction

The precondition for the work described in the following is a turbocharger removed from the
engine (see chapter Removal and installation [➙ 29]).
Further operations
This Operation Manual may be used to carry out only those operations that
are described in it. If the cartridge group is disassembled or assembled in-
CAUTION
correctly, this can lead to serious engine damage.
ABB Turbo Systems recommends having further operations carried out

only by trained staff or an ABB Turbocharging Service Station.
Marking casing position for assembly
ABB Turbo Systems recommends marking the casing positions prior to di-
sassembly.
NOTICE
Identification of the assembly devices
Not all assembly devices are marked with a part number. Identification is guaranteed by the
tool list. This list is enclosed in the toolbox.
Servicing the assembly devices
Assembly devices must be checked for damage before and after use.
WARNING
Visually inspect for corrosion, cracks, deformation and wear.

Damaged assembly devices must no longer be used and must be re-

placed.
Customer spare part set
Before starting operations, make sure the required customer spare part sets are available.
See chapter Spare parts [➙ 113].

© Copyright 2013 ABB. All rights reserved. HZTL2414_EN
Page 83 / 115
Revision B
March 2013