ABB A140-H56 Operation Manual page 57

Operation Manual / A130-H.. - A140-H..
7 Operation and service
7.2.1 Service procedures every 25 ... 50 hours
Visual control for air, exhaust gas, water, and oil leaks

Recording of operating data as well as entries in the engine logbook

In case of deviations, determine the cause.

Unknown operational changes
Impairment to the degree of a possible operating failure can be the conse-
quence.
CAUTION
Unknown causes must be clarified by an ABB Turbocharging Service Sta-

tion.
7.2.2 Service work at 100 hours after commissioning
Clean or replace the oil filter located in the supply pipe to the turbocharger while the engine

is stopped.
7.2.3 Service work according to instructions of enginebuilder
Clean or replace the oil filter located in the supply pipe to the turbocharger while the engine

is stopped.
7.2.4 Service work after 8000 ... 12000 hours of operation
Service work after 5 years the latest
After 5 years, engine damage can occur even though the specified operating
hours may not have been reached yet.
CAUTION
Carry out service work after 5 years the latest.

Shortened service intervals
Exceptional stresses (such as several starts/stops per day), harsh environ-
mental conditions or high system vibrations can lead to untimely engine da-
CAUTION
mage even if the prescribed service intervals were observed.
Agree on a shortened service interval with ABB Turbo Systems.

© Copyright 2013 ABB. All rights reserved. HZTL2414_EN
Page 55 / 115
Revision B
March 2013