Operation Manual / A130-H.. - A140-H..
4
Removal and installation
Gas-outlet casing (51100)
The gas-outlet casing (51100) may still be fitted in the exhaust gas pipe if
the locking nuts remain accessible for removing the turbocharger.
NOTICE
Observe the instructions for the fastening variant at hand.
Fastening the turbocharger with a standard nut [➙ 36] (A130 - A140)
Fastening the turbocharger with a clamping nut [➙ 37] (A140 only)
4.4.4
Fastening the turbocharger with a standard nut
Fit the nuts and tighten them according to variant 1 or 2 in the table below.
Product
A130
A135
A140
Table 3
Remove lifting gear.
© Copyright 2013 ABB. All rights reserved.
Fixing screws [mm]
M16
M20
M24
Variant 1:
Tightening torques [Nm]
280
560
960
HZTL2414_EN
Page 36 / 115
Variant 2:
Hydraulic pre-tensioning
forces [kN]
110
175
250
Revision B
March 2013